New: Twin Draft Guard Velvet • Cut to fit — no tools, no adhesive • Works all year, winter and summer
Twin Draft Guard

How to install your Twin Draft Guard Extreme

Six quick steps, no tools or adhesive. Watch the video or follow along below.

Download PDF
In the box
1 fabric sleeve [CONFIRM]
2 foam tubes [CONFIRM]
You'll need
Tape measure
Scissors or a serrated knife (only if trimming)
Step 1: Measure your door
1
Measure your door
Hold a foam tube against the bottom of the door to see how much length you need.
Step 2: Cut the foam to fit
2
Cut the foam to fit
Trim the foam tubes with scissors so they match the width of your door.
Step 3: Insert the foam tubes
3
Insert the foam tubes
Slide a foam tube into each side of the Extreme cover until it sits fully inside.
Step 4: Slide it under the door
4
Slide it under the door
Open the door and slide the guard underneath so one tube rests on each side.
Step 5: Center it on the door
5
Center it on the door
Line it up so the door sits between the two tubes along its full width.
Step 6: Open and close the door
6
Open and close the door
The guard moves with the door, sealing out drafts from both sides.

Care

Slide the foam tubes out before cleaning the cover.
Clean the fabric cover following its care label.
Let the cover dry fully before putting the tubes back.

Tips

Works on carpet, tile, hardwood and linoleum.
Made for gaps up to about 1" under the door.
Cut a little at a time — you can always trim more.